Combi Flash 7650 Series Uživatelský manuál stáhnout pdf (Strana 45)

Section 2 Preparation

2-25

2. Using the two long screws with lock and flat washers,

mount the metal tee fitting on the rear panel, aligning the

two standoffs over the ELSD’s threaded mounting holes,

and the mounting holes in the tee over the two standoffs.

Figure 2-17 Replace the PEEK tee with the metal tee fitting

3. Locate the 6" piece of tubing. Attach one end to the bottom

of the metal tee fitting and the other end to the ELSD

liquid inlet (refer to Figure 2-19). Tighten fittings to finger,

tight.

4. On the Torrent, disconnect the black PTFE tubing end

from the bottom column connection (Figure 2-18).

Standoffs (place over

threaded holes)

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 158 159

Žádné komentáře

Combi Flash 7650 Series Uživatelský manuál Strana 45